About getting passwords to access the remotes

Many people are asking me to give them a password to access the remote systems. I'm sorry but I can't help you there. You need to contact the OWNER of the remote system you want to use and ask them for the password. This includes the W4MQ remote system since I do not run it. I can only give passwords for my own remote when it comes on the Internet in another week or so. Even then my own system will be more for software testing use rather than remote operations full time.

Again, I CAN NOT GIVE PASSWORDS OUT FOR ANY OTHER SYSTEM OTHER THAN MY OWN when it comes online. Simply contact the owner of the remote you want to use and request a password from them if it is an open system. Some are, others aren't open for general use.

Bob N2JEU

 

Question for IRB Owners

Submitted by W6PJ on Sat, 05/30/2009 - 2:41pm.

Is anyone using the ADR2200 to select antennas and if so is it working properly with IRB host version 6.002.006? I have been using this board for a number of years and it worked with previous versions. I have tested the board and it's connections using hyperterminal so I know the board is working properly. I have uninstalled and re-installed the software with out solving the problem. Any thoughts?

73,
Pete, W6PJ

ADR2200

Submitted by Guest User on Sun, 05/31/2009 - 6:39am.

Hi Pete

I have two of these boards running with version 6.002.006 for years now without any problems. Did you check your com-definitions in the host.ini-file, do they match with the number of the available com-port in the hardware manager? The only problem I had in the past, that the rs232-connector was put in the wrong socket (the one which is used for daisy-chaining several boards) when rearranging a station.

73 de Mark, HB9AZT

ADR2200

Submitted by W6PJ on Tue, 06/09/2009 - 10:18pm.

Hi Mark,

Thanks for your response. Sounds like the software is fine based on your info. I seem to have the right COM port and parameters since I can control the board from hyperterminal on the host computer. Maybe my host.ini file is corrupted. I would have responded sooner, but just saw your post today.

73, Pete